Logo

Chemically amplified molecular resists for electron beam lithography

Robinson, A.P.G and Mohd Zaid, Hasnah (2006) Chemically amplified molecular resists for electron beam lithography. Microelectronic Engineering, 83 .

[img] PDF - Published Version
Restricted to Registered users only

261Kb

Abstract

Molecular resists, such as fullerene and triphenylene derivatives, use small carbon rich molecules, which give the potential for greater resolution, lower line edge roughness and higher etch durability than traditional polymeric materials. Their main limitation has been low sensitivity to irradiation. Here the chemical amplification of fullerene and triphenylene negative tone molecular resists is demonstrated. The sensitivity of a fullerene resist to 20 keV electrons was improved from 550 to 8 lC/cm2 by addition of an epoxide crosslinker and photoinitiator. Lines of width 25 nm were written using 30 keV electrons. A triphenylene with pendant epoxy groups was also studied. In this case the sensitivity reached on addition of photoinitiator was 7.5 lC/cm2 at 20 keV and lines of width 40 nm have been achieved at 30 keV.

Item Type:Article
Subjects:Q Science > QC Physics
Departments / MOR / COE:Departments > Fundamental & Applied Sciences
ID Code:882
Deposited By: Dr Hasnah Mohd Zaid
Deposited On:25 Mar 2010 02:00
Last Modified:19 Jan 2017 08:27

Repository Staff Only: item control page

Document Downloads

More statistics for this item...