Logo

EFFECT OF THERMOPLASTIC COPOLYMERS ON MICROSTRUCTURE AND VISCOELASTIC BEHAVIOUR OF BITUMEN

Habib, Noor Zainab and Kamaruddin, Ibrahim and Napiah, Madzlan and Isa, M Tan (2011) EFFECT OF THERMOPLASTIC COPOLYMERS ON MICROSTRUCTURE AND VISCOELASTIC BEHAVIOUR OF BITUMEN. In: Proceeding of Malaysian Universities Transportation Research Forum and Conferences 2010, 21 December 2010, Universiti Tenaga Nasional. (Submitted)

Full text not available from this repository.

Abstract

This paper presents a part of research to study the effect of the thermoplastic copolymer namely linear low density polyethylene (LLDPE), High density polyethylene (HDPE) and Polypropylene (PP) modified on 80 pen bitumen, using the rheological and morphological parameter. The modification of bitumen by the use of polymers enhances its performance characteristics but significantly affects its rheological properties. The tools used for rheological study of polymer modified bitumen (PMB) were penetration, ring & ball softening point and viscosity test. The morphological analysis was done to study the compatibility of bitumen with polymer, through field emission scanning electron microscopy (FESEM). The results were then related to the changes in the rheological properties of polymer modified bitumen. It was observed that thermoplastic copolymer shows profound effect on penetration rather than softening point. From the viscosity results it is revealed that the viscoelastic behaviour of PMB depend on the concentration of polymer in the mix, mixing temperature, mixing technique, solvating power of base bitumen and molecular structure of polymer used. PP offer better homogeneous blend in comparison to LLDPE and HDPE. The viscosity of base bitumen was enhanced with the addition of polymer and pseudoplastic behavior was also observed for LLDPE and HDPE. Oxidation during blending at 160ºC may be one of the causes of hardness of PMB. The best results were obtained when polymer concentration was kept below 3% for HDPE and LLDPE. PP shows least variation in all the test results.

Item Type:Conference or Workshop Item (Paper)
Subjects:T Technology > TA Engineering (General). Civil engineering (General)
Departments / MOR / COE:Departments > Civil Engineering
ID Code:7246
Deposited By: Assoc Prof Dr Isa Mohd Tan
Deposited On:19 Dec 2011 00:54
Last Modified:28 Mar 2014 07:42

Repository Staff Only: item control page